ASTM-E1251:2004 Edition

$44.96

E1251-04 Test Method for Analysis of Aluminum and Aluminum Alloys by Atomic Emission Spectrometry

Published By	Publication Date	Number of Pages
ASTM	2004	10

Guaranteed Safe Checkout

Categories: 77.120.10 - Aluminium and aluminium alloys, ASTM

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

1.1 This test method describes the analysis of aluminum and its alloys by atomic emission spectrometry. The aluminum specimen to be analyzed may be in the form of a chill cast disk, casting, foil, sheet, plate, extrusion or some other wrought form or shape. The elements covered in the scope of this method are listed in the table below.

Note 1The conncentration ranges given in the above scope were established through cooperative testing (ILS) of selected reference materials. The range shown for each element does not demonstrate the actual usable analytical range for that element. The usable analytical range may be extended higher or lower based on individual instrument capability, spectral characteristics of the specific element wavelength being used and the availability of appropriate reference materials.

1.2 This test method is suitable primarily for the analysis of chill cast disks as defined in Practices E 716. Other forms may be analyzed, provided that: (1) they are sufficiently massive to prevent undue heating, (2) they allow machining to provide a clean, flat surface, which creates a seal between the specimen and the spark stand, and (3) reference materials of a similar metallurgical condition and chemical composition are available.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. Specific safety and health statements are given in Section 10.

Additional information

Zirconium	0.001 to 0.12
Manganese	0.001 to 1.2
Copper	0.001 to 5.5
Magnesium	0.03 to 5.4
Silicon	0.07 to 4.0
Nickel	0.005 to 2.6
Titanium	0.001 to 0.12
Tin	0.03 to –
Lead	0.04 to 0.6
Chromium	0.001 to 0.23
Bismuth	0.03 to 0.6
Beryllium	0.0004 to 0.24
Sodium	0.003 to 0.02
Boron	0.0006 to 0.009
Strontium	0.003 to –
Zinc	0.002 to 5.7
Cobalt	0.4 to –
Iron	0.2 to 0.5
Phosphorus	0.003 to 0.003
Lithium	0.0003 to 2.1
Vanadium	0.002 to 0.022
Element	Tested Concentration Range(Wt %)
Calcium	0.0002 to –
Gallium	0.02 to –
ICS Codes	77.120.10 - Aluminium and aluminium alloys

Preview PDF


PDF Format	Searchable	Printable	Preview Now

ASTM-E1251:2004 Edition

Related products