ASTM-F1865:2009 Edition

ASTM F1865

Scope

1.1 This specification covers mechanical cold expansion insert fittings with compression sleeve suitable for use with cross-linked polyethylene PEX plastic tubing in ³/₈, ½, ⁵/₈, ¾ , and 1in. and larger nominal diameters that meet the requirements of Specifications F 876 and F 877. These fittings are intended for use in 100 psi (689.5 kPa) cold and hot water distributions systems operating at temperatures up to and including 180° F (82°C). Included are the requirements for materials, workmanship, dimensions, and markings to be used on the fittings and compression sleeves

1.2 The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

Keywords

cold and hot water distribution; cold expansion insert fittings; compression sleeve; crosslinked polyethylene; PEX; Cold expansion insert fittings–specifications; Cold water supply/distribution systems–specifications; Compression sleeve; Crosslinked polyethylene (PEX) pipe/tube–specifications; Hot water supply/distribution systems–specifications; Polyethylene (PE) tube–specifications

ICS Code

ICS Number Code 23.040.45 (Plastic fittings)

DOI: 10.1520/F1865-02AR09