Shopping Cart

No products in the cart.

BS EN 61032:1998:2003 Edition

$142.49

Protection of persons and equipment by enclosures. Probes for verification

Published By Publication Date Number of Pages
BSI 2003 30
Guaranteed Safe Checkout
Category:

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Gives details and dimensions of test probes intended to verify the protection provided by enclosure with regard to: a) protection of persons against access to hazardous parts inside the enclosure. b) protection of equipment inside the enclosure against ingress of solid foreign objects.

PDF Catalog

PDF Pages PDF Title
1 BRITISH STANDARD
2 National foreword
3 Contents
6 Foreword
Contents
9 1. General
1.1 Scope and object
1.2 General recommendations
2 Normative references
3 Definitions
3.1 enclosure
10 3.2 hazardous part
3.2.1 hazardous live part
3.2.2 hazardous mechanical part
3.2.3 hazardous hot or glowing part
3.3 access probe
3.4 object probe
3.5 IP code probe
3.6 other probe
3.7 adequate clearance for protection against access to hazardous parts
4 Classification of test probes
11 5 List of test probes
Table 1 – List of test probes
12 6 Test probes
6.1 IP code probes
Figure 1 – Test probe A
13 Figure 2 – Test probe B
14 Figure 3 – Test probe C
Figure 4 – Test probe D
15 Figure 5 – Test probe 1
Figure 6 – Test probe 2
6.2 Other access probes
16 Figure 7 – Test probe 11
Figure 8 – Test probe 12
17 Figure 9 – Test probe 13
Figure 10 – Test probe 14
18 Figure 11 – Test probe 17
Figure 12 – Test probe 18 (small finger probe Ø 8,6)
19 Figure 13 – Test probe 19 (small finger probe Ø 5,6)
20 Figure 14 – Test probe 31
Figure 15 – Test probe 32
21 Figure 16 – Test probe 41
Figure 17 – Test probe 43
7 Design characteristics of test probes
7.1
7.2
22 Annex A (informative)
Effect of tolerances of test probes on equipment and test results
A.1 General
A.2 Test probes of undefined length
Figure A.1 – Tolerance range on the diameter of a cylindrical test probe
23 A.3 Test probes of defined length
Figure A.2 – Tolerance range on the length of a test probe
A.4 Test probes with tapered section
24 Figure A.3 – Variation of penetration depth
25 Figure A.4 – Tolerance range of the penetration depths
Figure A.5 – Tolerance range of the penetration depths
26 Figure A.6 – Tolerance range of the penetration depths
Figure A.7 – Tolerance range of the penetration depths
27 Annex B (informative)
Rules for tolerancing future probes
B.1 Dimensions
B.1.1
B.1.2
B.2 Forces
28 Annex ZA (normative)
Normative references to international publications with their corresponding European …
BS EN 61032:1998
$142.49