BS EN IEC 61169-67:2022

$142.49

Radio frequency connectors – Sectional specification for series TRL threaded triaxial connectors

Published By	Publication Date	Number of Pages
BSI	2022	26

Guaranteed Safe Checkout

Categories: 33.120.30 - RF connectors, BSI

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

This part of IEC 61169, which is a sectional specification (SS), provides information and rules for the preparation of detail specifications (DS) for series TRL threaded triaxial connectors. Series TRL threaded triaxial connectors with high reliability, small size, good salt characteristics can be connected with symmetrically twisted pair cables or triaxial cables. It has been used in 1553B data bus systems or other communication systems for digital signal transmission. It prescribes mating face dimensions for series TRL threaded triaxial connectors, gauging information and tests selected from IEC 61169-1, applicable to all detail specifications relating to series TRL threaded triaxial connectors. This specification indicates recommended performance characteristics to be considered when writing a detail specification and it covers test schedules and inspection requirements for assessment levels M and H. Note: Metric dimensions are original dimensions. All undimensioned pictorial configurations are for reference purpose only.

PDF Catalog

PDF Pages	PDF Title
2	undefined
5	Annex ZA (normative)Normative references to international publicationswith their corresponding European publications
6	Blank Page
7	English CONTENTS
8	FOREWORD
10	1 Scope 2 Normative references 3 Terms and definitions
11	4 Mating face and gauge information 4.1 Mating face dimensions 4.1.1 Plug connector Figures Figure 1 – Plug connector Tables Table 1 – Dimensions of plug connector
12	4.1.2 Receptacle connector 4.1.3 Coaxial pin contact Figure 2 – Receptacle connector Table 2 – Dimensions of receptacle connector
13	4.1.4 Coaxial socket contact Figure 3 – Coaxial pin contact Figure 4 – Coaxial socket contact Table 3 – Dimensions of coaxial pin contact Table 4 – Dimensions of coaxial socket contact
14	4.2 Gauges for resilient contact 4.2.1 Gauge for socket centre contact 4.2.2 Gauge for socket intermediate contact Figure 5 – Gauge for socket centre contact Table 5 – Dimensions of gauge for socket centre contact
15	5 Quality assessment procedure 5.1 General 5.2 Ratings and characteristics Figure 6 – Gauge for socket intermediate contact Table 6 – Dimensions of gauge for socket intermediate contact
16	Table 7 – Ratings and characteristics
18	5.3 Test schedule and inspection requirements 5.3.1 Acceptance tests Table 8 – Acceptance tests
19	5.3.2 Periodic tests Table 9 – Periodic tests
20	5.3.3 Procedures 6 Instructions for preparation of detail specifications (DS) 6.1 General
21	6.2 Identification of the component 6.3 Performance 6.4 Marking, ordering information and related matters 6.5 Selection of tests, test conditions and severities
22	6.6 Blank detail specification pro-forma for TRL connectors