BS ISO 30021:2013
$102.76
Plastics. Burning behavior. Intermediate-scale fire-resistance testing of fibre-reinforced polymer composites
| Published By | Publication Date | Number of Pages |
| BSI | 2013 | 18 |
This International Standard specifies a method of determining the fire resistance of non-load-bearing separating elements made of fibre reinforced plastics (FRP) when exposed to heating on one face.
It is applicable to FRP products for which the end-use application is smaller than the full-scale fire test specimen specified in ISO 834-1. Fire barriers in transportation applications are a common example, since the end-use dimensions of the barrier products are often smaller than those specified in ISO 834-1.
This test is, in general, applicable to FRP products which have an essentially flat surface and can have stiffening members. This includes sandwich-panel-type structures in which the skins consist of FRP.
CAUTION — The attention of all persons concerned with managing and carrying out this fire-resistance test is drawn to the fact that fire testing is hazardous and there is a possibility of toxic and/or harmful smoke and gases being evolved during the test. Mechanical and operational hazards can also arise during the construction of the test elements or structures, their testing and disposal of test residues.
It is essential that an assessment of all potential hazards and risks to health is made and safety precautions are identified and provided. It is also essential that written safety instructions are issued, that appropriate training is given to relevant personnel and that laboratory personnel ensure that they follow written safety instructions at all times.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 6 | Foreword |
| 7 | Introduction |
| 9 | Section sec_1 Section sec_2 Section sec_3 Section sec_4 1 Scope 2 Normative references 3 Terms and definitions 4 Principle |
| 10 | Section sec_5 Section sec_5.1 Section sec_5.2 Section sec_6 Section sec_6.1 Section sec_6.2 Section sec_6.3 Section sec_6.4 5 Test equipment 5.1 General 5.2 Specimen mounting frame 6 Test specimen 6.1 Number of specimen 6.2 Dimensions 6.3 Structure of specimen 6.4 Insulation of specimen |
| 11 | Section sec_7 Section sec_8 Section sec_8.1 Section sec_8.2 Table tab_a Figure fig_1 7 Conditioning 8 Application of instrumentation 8.1 Plate thermometer 8.2 Temperature measuring points of the test specimen |
| 12 | Section sec_9 Section sec_9.1 Section sec_9.2 Section sec_9.3 Section sec_9.4 Section sec_9.5 Section sec_9.6 Section sec_9.6.1 Section sec_9.6.2 Section sec_9.6.3 Section sec_9.6.4 9 Test procedures 9.1 Temperature of the test room 9.2 Specimen mounting 9.3 Temperature before the commencement of the test 9.4 Commencement of the test 9.5 Heating condition 9.6 Measurement and observation |
| 13 | Section sec_9.6.5 Section sec_9.6.6 Section sec_9.7 Section sec_9.8 Section sec_10 9.7 Termination of test 9.8 Observations after the test 10 Test report |
| 15 | Reference ref_1 Reference ref_2 Reference ref_3 Reference ref_4 Reference ref_5 Bibliography |
