IEEE 1019 2013
$48.75
IEEE Recommended Practice for Specifying Electric Submersible Pump CablePolypropylene Insulation
Published By | Publication Date | Number of Pages |
IEEE | 2013 | 44 |
Revision Standard – Active. Minimum requirements for the design, construction, manufacturing, testing, purchasing, and application of electric submersible pump cable are presented. The cable is round or flat, with polypropylene rubber insulation, nitrile or polyethylene jacket, and armor. These cables are for voltages not exceeding 3 kV or 5 kV (phase to phase) and conductor temperatures not exceeding 96 C (205 F) maximum for nitrile or a maximum minimum of 10 C (14 F) minimum. Conductors, insulation, assembly and with or without jacket, armor, requirements for testing by the manufacturer, and cable ampacity are all covered in the document.
PDF Catalog
PDF Pages | PDF Title |
---|---|
1 | IEEE Std 1019ā¢-2013 Front Cover |
3 | Title page |
6 | Notice to users Laws and regulations Copyrights Updating of IEEE documents Errata |
7 | Patents |
8 | Participants |
10 | Introduction |
11 | Contents |
13 | 1. Overview 1.1 Scope 1.2 Specification and standards |
14 | 1.3 Application considerations |
15 | 2. Normative references |
16 | 3. Conductors 3.1 Material 3.2 Construction |
17 | 3.3 Conductivity 4. Insulation 4.1 Material |
18 | 4.2 Construction 4.3 Gas blockage for stranded conductors 5. Assembly and Jacket 5.1 Material |
19 | 5.2 Construction |
20 | 6. Armor 6.1 Material |
21 | 6.2 Construction 7. Manufacturersā electrical test requirements 7.1 Conductor testing 7.2 Electrical testing |
26 | 8. Cable ampacity 8.1 Ampacity |
27 | 8.2 Temperature 8.3 Safety factor 8.4 Conductor size |
28 | 8.5 Economics 9. Tutorial information 9.1 Special terms |
31 | 9.2 Application considerations |
33 | 9.3 Wellhead with connections |
34 | Annex A (informative) Cable designs and components |
36 | Annex B (informative) Figures |