AWWA C710 2009

$75.83

AWWA C710-09: Cold Water Meters-Displacement Type, Plastic Main Case

Published By	Publication Date	Number of Pages
AWWA	2009	40

Guaranteed Safe Checkout

Category: AWWA

If you have any questions, feel free to reach out to our online customer service team by clicking on the bottom right corner. We’re here to assist you 24/7.
Email:[email protected]

Description

This standard describes the various types and classes of cold-water displacement meters with plastic main cases, in sizes 1/2 in. (13 mm) through 1 in. (25 mm), for water utility customer service, and the materials and workmanship employed in their fabrication. The displacement meters described, known as nutating-disc or oscillating-piston meters, are positive in action because the pistons and discs displace or carry over a fixed quantity of water for each nutation or oscillation when operated under positive pressure.

PDF Catalog

PDF Pages	PDF Title
1	ANSI/AWWA C710-09
3	Committee Personnel
5	Contents
7	Foreword I. Introduction.
9	II. Special Issues.
10	III. Use of This Standard.
11	IV. Major Revisions. V. Comments.
13	AWWA Standard Cold-Water Meters-Displacement Type, Plastic Main Case SECTION 1: GENERAL Sec. 1.1 Scope Sec. 1.2 Purpose Sec. 1.3 Application
14	SECTION 2: REFERENCES Sec. 2.1 Standards
16	Sec. 2.2 ASTM Test Standards SECTION 3: DEFINITIONS
17	SECTION 4: REQUIREMENTS Sec. 4.1 Materials
21	Sec. 4.2 General Design
22	Table 1 Characteristics of displacement-type meters
23	Table 2 Dimensional design limits for meters and external connections
24	Sec. 4.3 Detailed Design
25	Table 3 Maximum indication on initial dial and minimum register capacity
26	SECTION 5: VERIFICATION Sec. 5.1 Rejection SECTION 6: DELIVERY Sec. 6.1 Marking Sec. 6.2 Packaging and Shipping Sec. 6.3 Affidavit of Compliance
27	APPENDIX A Bibliography
29	APPENDIX B Supplemental Information SECTION B.1: UNITS OF MEASURE SECTION B.2: TESTS Sec. B.2.1 Capacity and Pressure-Loss Tests
30	Sec. B.2.2 Pressure Tests Sec. B.2.3 Accuracy Tests SECTION B.3: TESTING EQUIPMENT
31	SECTION B.4: REGISTRATION ACCURACY Sec. B.4.1 Excessive Wear Sec. B.4.2 Temperature Extremes
32	Sec. B.4.3 Corrosion Sec. B.4.4 Materials in Suspension Sec. B.4.5 Entrained Air
33	Table B.1. Most frequently used intervals between meter tests SECTION B.5: PERIODIC TESTS Sec. B.5.1 Time Intervals SECTION B.6: METER STORAGE
34	SECTION B.7: MATERIALS SECTION B.8: INSTALLATION Sec. B.8.1 Electrical Grounded Pipe Systems
35	Sec. B.8.2 Misaligned Pipes Sec. B.8.3 Meter Installation Methods
36	Sec. B.8.4 Placing Meter in Service