BS 8416:2002
$102.76
Specification for hole-saws
| Published By | Publication Date | Number of Pages |
| BSI | 2002 | 22 |
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | BRITISH STANDARD |
| 2 | Committees responsible for this British Standard |
| 3 | Contents |
| 5 | 1 Scope 2 Normative references 3 Terms and definitions 3.1 hole-saw 3.2 cutting edge 3.3 body 3.4 cap 3.5 teeth 3.6 body thickness 3.7 tooth pitch |
| 6 | 3.8 tooth depth 3.9 Cutting plane Figure 1 – Pitch and depth 4 Hole-saw types 4.1 Toothed hole-saws Figure 2 – Toothed hole-saw (typical construction) |
| 7 | 4.2 Tipped toothed hole-saws 4.3 Abrasive grit-edged hole-saws 5 Design 5.1 Construction 5.2 Direction of rotation 5.3 Heat treatment 5.4 Finish 5.5 Screw threads 5.6 Morse tapers 5.7 Standard diameters |
| 8 | Table 1 – Standard hole-saw sizes 5.8 Depth 5.9 Driving arbors interfaces |
| 9 | Figure 3 – Hole-saw type I |
| 10 | Figure 4 – Hole-saw type II |
| 11 | Figure 5 – Hole-saw type III |
| 12 | Figure 6 – Hole-saw type IV |
| 13 | 5.10 Concentricity Table 2 – Tolerances for hole-saw concentricity 5.11 Cutting edge variation 6 Hole-saw arbors 6.1 General Table 3 – Hole-saw arbor dimensions 6.2 Hole-saw arbor type I 6.3 Hole-saw arbor type II 6.4 Hole-saw arbor type III |
| 14 | Figure 7 – Hole-saw arbor type I Figure 8 – Hole-saw arbor type II |
| 15 | Figure 9 – Hole-saw arbor type III |
| 16 | 7 Hole-saw accessories 7.1 Pilot drills Figure 10 – Pilot drill for use with arbor type I |
| 17 | Figure 11 – Pilot drill for use with arbor type I (tipped) Figure 12 – Pilot drill for use with arbor type II and III |
| 18 | Figure 13 – Pilot drill for use with arbor type II and III (tipped) 7.2 Arbor extension 7.3 Morse taper adapter |
| 19 | Figure 14 – Arbor extension |
| 20 | Figure 15 – Morse taper adapter |
| 21 | 8 Marking 9 Instructions for use |
