BS EN 16974:2016
$102.76
Conveyor belts. Indentation rolling resistance related to belt width. Requirements, testing
| Published By | Publication Date | Number of Pages |
| BSI | 2016 | 16 |
This draft European Standard defines a method for the determination of the width related indentation rolling resistance of conveyor belts. The goal is that the method easily and quickly delivers values which are reproducible and relevant for the practical use. The test results enable a comparing evaluation and the design of belt conveyors with steelcord and fabric conveyor belts. This draft European Standard is not suitable or valid for light conveyor belts described in EN ISO 21183 1.
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 5 | European foreword |
| 6 | 1 Scope 2 Normative references 3 General information |
| 7 | 4 Symbols and units Table 1 — Symbols and units |
| 8 | Table 2 — Indices 5 Test rig Figure 1 — Schematic picture of the test rig |
| 9 | 6 Preparation of test samples 7 Procedure |
| 10 | 8 Calculation and expression of results Figure 2 — Example for the variation of the width related indentation rolling resistance F´E depending on the width related vertical force F´M,v under consideration of the ambient temperature TU 9 Test report |
| 12 | Annex A (informative) Conversion of the measured width related indentation rolling resistance to a 3-part idler station Figure A.1 — Idealized distribution of the normal forces along the idler shells and the resulting indentation rolling resistance for a 3-part idler station with idlers of the same length |
| 14 | Bibliography |
