ICC UniformMechanicalCode 1994
$24.10
Uniform Mechanical Code
| Published By | Publication Date | Number of Pages |
| ICC | 1994 | 331 |
No Description
PDF Catalog
| PDF Pages | PDF Title |
|---|---|
| 1 | 1994 UNIFORM MECHANICAL CODE |
| 4 | PREFACE |
| 5 | CODES AND RELATED PUBLICATIONS |
| 8 | CONTENTS |
| 16 | CHAPTER 1 ADMINISTRATION PART I—GENERAL |
| 18 | PART II—ORGANIZATION AND ENFORCEMENT |
| 20 | PART III—PERMITS AND INSPECTIONS |
| 27 | CHAPTER 2 DEFINITIONS |
| 41 | CHAPTER 3 GENERAL REQUIREMENTS FOR HEATING, VENTILATING AND COOLING |
| 62 | CHAPTER 4 VENTILATION AIR SUPPLY |
| 64 | CHAPTER 5 EXHAUST SYSTEMS |
| 78 | CHAPTER 6 DUCT SYSTEMS |
| 92 | CHAPTER 7 COMBUSTION AIR |
| 96 | CHAPTER 8 CHIMNEYS AND VENTS |
| 113 | CHAPTER 9 SPECIAL FUEL-BURNING EQUIPMENT |
| 117 | CHAPTER 10 BOILER/WATER HEATERS |
| 118 | CHAPTER 11 REFRIGERATION |
| 135 | CHAPTER 12 HYDRONIC PIPING |
| 136 | CHAPTER 13 FUEL GAS PIPING |
| 137 | CHAPTER 14 SPECIAL PIPING AND STORAGE SYSTEMS |
| 138 | CHAPTER 15 SOLAR SYSTEMS |
| 139 | CHAPTER 16 UNIFORM BUILDING CODE, UNIFORM MECHANICAL CODE AND UNIFORM FIRE CODE STANDARDS |
| 147 | APPENDIX A UMC STANDARD 2-2 GALVANIZED SHEET METALS |
| 150 | UMC STANDARD 6-1 FACTORY-MADE AIR DUCTS |
| 166 | UMC STANDARD 6-2 STANDARD FOR METAL DUCTS |
| 191 | UMC STANDARD 6-3 TEST METHOD FOR FIRE AND SMOKE CHARACTERISTICS OF ELECTRICAL CABLE AND PLASTIC SPRINKLER PIPE |
| 203 | UMC STANDARD 6-5 STANDARD FOR INSTALLATION OF FACTORY-MADE AIR DUCTS |
| 244 | UMC STANDARD 11-1 Standard Test Method of Concentration limits of Flammability of Chemicals |
| 252 | UMC STANDARD 11-2 METHODS FOR SYSTEM IDENTIFICATION |
| 255 | UFC STANDARD 2-2 FLASH POINT BY PENSKY-MARTENS CLOSED TESTER |
| 257 | APPENDIX B CHAPTER 10 STEAM AND HOT-WATER BOILERS |
| 267 | CHAPTER 12 HYDRONICS PART I—HYDRONIC PIPING |
| 273 | PART II—HYDRONIC PANEL HEATING SYSTEMS |
| 275 | CHAPTER 13 FUEL-GAS PIPING |
| 292 | CHAPTER 14 PROCESS PIPING |
| 296 | CHAPTER 15 SOLAR SYSTEMS |
| 297 | APPENDIX C CHAPTER 8 SIZING OF VENTING SYSTEMS SERVING APPLIANCES EQUIPPED WITH DRAFT HOODS AND APPLIANCES LISTED FOR USE WITH TYPE B VENTS |
| 308 | APPENDIX D TABLE D-1 APPROXIMATE MINIMUM THICKNESS FOR CARBON SHEET STEEL CORRESPONDING TO MANUFACTURER’S STANDARD GAGE AND GALVANIZED SHEET GAGE NUMBERS |
| 310 | UNIT CONVERSION TABLES |
| 314 | INDEX |
